So funktioniert's
Install BLADE® beer dispenser
-
Plug in the deviceConnect BLADE® to the mains.
-
Press the orange buttonOnly use kegs that have been pre-chilled in the refrigerator or in a cold room. Press the orange button on the underside of the keg with your thumb until you hear a click. After that, your keg is ready for tapping!
-
Connect kegInsert a pre-chilled keg. Route the hose to the tap valve and bend down towards the bracket.
-
Put the dome on topPut the dome on the device to keep the contents cool.
-
Turn on BLADE®Gerät über EIN-/AUSSCHALTER auf der rechten Seite einschalten.
-
Lock the kegÜber den Schalter das Fass VERRIEGELN (CLOSE). Die Kontrollleuchte sollte nun grün leuchten.
-
Check temperatureÜberprüfen Sie vor dem Zapfen die richtige Zapftemperatur anhand der Anzeige. Die Fässer sollten vor der Verwendung mindestens 16 Stunden bei einer Temperatur zwischen 0–4 °C kühl gelagert werden.
Tap a fresh beer
-
Check the temperature of the beer keg
-
Hold the glass at a 45 degree angle
-
Pull the tap handleWith the angle you can regulate the foam height: the more inclined you hold the glass, the less foam you get
-
The perfect foam head is about two fingers thick
Remove a BLADE® keg
-
Pull the switch up to unlock the keg
-
Remove the dome
-
Rotate the tap unit cover down
-
Remove the beer hose from the holder
-
Remove the keg and insert a new one
